Features 2 Wingtip Lights (1-Red, 1-Green), 2 Landing Lights (White), 2 Asynchronous Strobes (2-White or 1-White/1-Red), as well as a servo speed reducer that will slow the movement of any proportional servo for more realistic, scale-like movement of flaps or even retracts. Unit plugs into any spare channel, or can be combined with retracts or flap servos using a regular servo "y". High-brightness LEDs and a low-drain microcontroller circuit mean that it can be safely powered by the receiver's battery, no extra battery is required.

IMPORTANT NOTE: This circuit is NOT regulated, it is designed to operate on a receiver that powered by either a 4-5 cell Ni-MH pack, or a 5.0 volt BEC or ESC with an on-board BEC. If you are using it on an HV (high voltage) receiver powered by a 2S (or larger) Li-Po/Li-Ion/LiFe, you will need a separate 5.0 volt BEC or a voltage regulator. Both are available in our store, check under Navigation Lights or under Parts and Connectors.

Check our "Videos" page under "Navigation Lights" for a short demonstration video!

Related Items:
5mm LED Holders
6-pin Connectors (for wing disconnects)

DOWNLOAD: Ultimate NavLights Manual

Ultimate NavLights w/Servo Slow-5mm

$45.00

Strobe Color

Quantity

High-brightness 5mm LEDs, these are the brightest 5mm LEDs I can find anywhere! Each LED draws ~20-25mA (the strobe LEDs draw much less, and landing light LEDs only draw when they are switched "on"), so total current use is very low, around 125mA or less maximum. Wire lengths are 30" each for Wingtip LED and Landing Light LED, 60" on Strobe LED, and all wires can be easily shortened or lengthened as needed using regular speaker or zip wire.

The Ultimate NavLights feature 2 special features not found on my other NavLight circuits. First is the servo speed reducing feature, which slows the movement of any proportional servo to make the movement of flaps or retracts more scale-like. Second is the use of 2 separate strobe circuits, which provides you with strobes that each double-blink independently of one another in an asychronous pattern. The 2 Wingtip Lights and the both Strobes come on as soon as the receiver is powered "ON", while the 2 white Landing Lights come on as soon as the channel is toggled to lower flaps or retracts. Action of the Landing Lights is reversable via a small jumper on the circuit board. Instructions are included for easy installation and use.

IMPORTANT NOTE: The servo slow down function of this device will only work on a regular, proportional servo. It will NOT work on a retract-type servo, as they do not recognize any servo positions other than clockwise (CW) and counter-clockwise (CCW). Retract servos cannot be slowed down, even by transmitters that include this function, as their design and electronics do not allow it. Check the FAQ page for more information on servo speed reduction.